Linear slide type NOG

At linear slides type NOG the two sliding parts (interior- and exterior part) has got a different length. The interior is the ground plate. Through the small gap between the two sliding parts the inner of the linear Slide is protected against dirt (gap dimension ca. 0,5 mm).

The sliding parts can be produced in grey cast iron (standard) or alternative aluminium. Stainless-steel upon request.
Informations about the height and permissible loads please read in the PDF.

On request different special versions are possible, please contact us.

ADVANTAGES

Smooth running
Minimal wear
Zero backlash
Stick-slip free run (no start-up friction)
Compatible with R and TV-slides
Cross Table assembly possible
High accleration (50m/s²)
High velocity (50m/min)

AREAS OF APPLICATION

Processing machine
Tooling machine
Precision engineering
Ideally suited for short oscillating movements
and many other

TECHNICAL DATA

Material	Standard version grey cast iron EN-GJS-400-15, alternative aluminium, other materials upon request
Min. & max. width	100 - 300 mm
Coefficient of friction	0.003
Lubrication	Rolling bearing grease based on lithium soap
Rolling elements	Needlerolls with Ø 2 mm
Sealing	Insensitive to dirt due its design
Slide execution	Surfaces ground, optionally chemically nickel-plated or natural anodized
Mounting hole	Without (standard), optionally with standard mounting holes or customer mounting holes
Maintenance	Low maintenance
Special dimensions and materials	Upon request

Linear slide type NOG